Better contact

I bought a new vacuum cleaner:)



I made a silicone sheet jig. The silicone sheet sometimes wimples while heating because it gets longer by heat. This jig gives a little tension which avoids wimpling.


I got perfectly saturated consistent black! For money savings, most of these caps are already printed test chart. Blank keycaps are expensive in my budget.


Printed on blank keycaps:

Perfectly saturated consistent black. I've gained some confidence with my method.

But I've found printing misalignment. I feel my keycap mount is not stable enough. In principle, plaster is highly stable. Aging is required? I went wrong while alignment? Anyhow, I have a plan to make new design keycap mount.